TERMINATION BAR

TERMINATION BAR is a high strength, plastic strip designed to support vertical membrane systems at their termination point. This plastic composite is ultraviolet resistant, will not rust, and is non-conductive for additional jobsite safety. Each strip has predrilled holes for easy installation.

FEATURES/BENEFITS
Pre-fabricated, ready to use/Cost effective.
Made of special, high strength plastic/Adapts to building wall irregularities.
Anchors a variety of material widths.
Trapezoidal design/Provides trough for caulks or mastic beads.
Non-corrosive/Will not rust.
Provides neat looking terminations/Professional appearance.
APPLICATION
Install TERMINATION BAR at the top edge of the material to be supported. If a sealant material is to be used at the top of the termination, place the narrow side of the trapezoidal design against the wall to form a reservoir for the sealant material. TERMINATION BAR is easily scored and cut to fit field dimensions. Use predrilled holes as necessary, with appropriate mechanical or power-actuated fasteners.

* Other accessories are available upon request.
** Please feel free to contact us if you didn’t find information you need here. We provide custom service, which will satisfy per your request.
*** Please contact us for Installing Guide.
**** Please contact us for Technical Data Sheet.

We manufacture but are not limited to the following accessories
● Inside corner /outside corner
● Square pipe boot /Round pipe boot
● Chimney Flashing
● T-joint
● Universal Corners
● Drop scupper, drainage, etc…
● Lightning Rod bracket
● Solar Panel Bracket
● Philips Head Screw
● Termination bar / U bar
● Plate